0.1～1100MHz 1.1GHz Frequency Counter Tester Measurement F Ham Radio PLJ-1601-C

Description

0.1～1100 MHz 0.1～ 1.1 GHz  Frequency Counter Tester Measurement For Ham Radio
Specification
:
Use 8 bit Microchip
PIC16F876A,up to 1.1GHz
Gate time
0.01 seconds
0.1 seconds
1.0 seconds
Measuring channels ( high and low channels are high impedance )
1)Low channel
Measuring range : 0.1MHz ~ 70MHz
Measurement accuracy:
± 100Hz ( 0.01 seconds gate )
± 10Hz ( 0.1 seconds gate )
± 1Hz ( 1.0 seconds gate )
Sensitivity:
0.1MHz ~ 10MHz: better than 50mVPP
10MHz ~ 60MHz: superior to 50mVPP
60MHz ~ 75MHz: not tested
2)High channel frequency (64 points )
Measuring range : 10MHz ~ 1.1GHz
Measurement Accuracy : ± 6400Hz (0.01 seconds gate )
± 640Hz ( 0.1 seconds gate )
± 64Hz ( 1.0 seconds gate )
High channel sensitivity : 10MHz ~ 30MHz: better than 100mVPP
30MHz ~ 60MHz: superior to 50mVPP
60MHz ~ 1.1GHz: not tested
Automatic channel is automatically selected based on the frequency of the input signal level of channel
Crystal measuring channel
Measuring range : 1 MHz ~ 50 MHz ( the most low-end and highest end untested )
3) .
Frequency reference
5032 package 13.000 MHz Warming voltage controlled crystal oscillator ( VC - TCXO) , frequency stability is ± 2.5 ppm
IF settings
The minimum frequency is adjustable in steps of 100 Hz, frequency range 0 ~ 999.9999 MHz, can be set to plus or minus IF mode
working voltage
DC input: DC 9V ~ 12V
working current
The backlight is enabled: ≤ 75 mA backlight disabling: ≤ 55 mA
Display
maximum of 9 digit display
physical dimensions
Length * width * height:  92mm × 37mm × 27mm
Board interface
RF INPUT (measuring signal input): XH2.54-2P curved needle square socket
ICSP INPUT (MCU interface): XH2.54-6P curved needle square socket
ECL INPUT (external clock input): XH2.54-2P curved needle square socket
POWER INPUT (Power Interface): ① with 3.5mm socket (DC is negative)
The XH2.54-2P curved needle square socket